Lost Video Island Forum Index Lost Video Island
A Multifandom Vidding site
 
 LVI Home   Search   Memberlist 
The forum is archived and read-only.

How Do I Remove Excess Time In My Timeline?

 
   Lost Video Island Forum Index -> Technical Vidding Help
AuthorMessage
FaradayLinus
Expert Vidder


Joined: 16 Jun 2009
Posts: 1525

PostPosted: Fri Jul 10, 2009 8:22 pm    Post subject: How Do I Remove Excess Time In My Timeline?

My video ends at 1:27, but the timeline keeps going until 2:15. How do I correct it so that when I render it, it doesn't include all that excess time?

Thanks for any help
Back to top 
Aislynn
Council Member

Joined: 03 Feb 2005
Posts: 35782

PostPosted: Fri Jul 10, 2009 10:34 pm    

Is there something on any of the timelines (audio or video) after your vid stops at 1:27? If so, delete it and that should take care of the problem.

Or you can do what I always do (because I dump a ton of clips on the timelines after my actual vids where I've tried out clips then didn't like them or didn't use them ), which is to highlight the vid from start to finish (you can check the timestamp to make sure it starts at 00:00 and ends at 1:27 to make sure you didn't accidentally cut anything off ) then I go to Render As and make sure that "render loop region" has a check next to it.

This is the same procedure as spot rendering, just in this case rendering the entire vid. Then that way I can control exactly how much the vid renders, in case it picks up some stray clip down the timeline and is trying to include that.
Back to top 
FaradayLinus
Expert Vidder


Joined: 16 Jun 2009
Posts: 1525

PostPosted: Fri Jul 10, 2009 10:49 pm    

Aislynn wrote:
Is there something on any of the timelines (audio or video) after your vid stops at 1:27? If so, delete it and that should take care of the problem.

Or you can do what I always do (because I dump a ton of clips on the timelines after my actual vids where I've tried out clips then didn't like them or didn't use them ), which is to highlight the vid from start to finish (you can check the timestamp to make sure it starts at 00:00 and ends at 1:27 to make sure you didn't accidentally cut anything off ) then I go to Render As and make sure that "render loop region" has a check next to it.

This is the same procedure as spot rendering, just in this case rendering the entire vid. Then that way I can control exactly how much the vid renders, in case it picks up some stray clip down the timeline and is trying to include that.


Thank you! The render loop region thing worked. Like you, I try out alot of clips which extends my timeline so the timeline always ends up longer than the video once I cut those clips. But yeah, everything worked out
Back to top 
   Lost Video Island Forum Index -> Technical Vidding Help All times are GMT
Page 1 of 1

Powered by phpBB © 2001, 2005 phpBB Group · archived 2026