Lost Video Island

[FaradayLinus]

My video ends at 1:27, but the timeline keeps going until 2:15. How do I correct it so that when I render it, it doesn't include all that excess time?

Thanks for any help

[Aislynn]

Is there something on any of the timelines (audio or video) after your vid stops at 1:27? If so, delete it and that should take care of the problem.

Or you can do what I always do (because I dump a ton of clips on the timelines after my actual vids where I've tried out clips then didn't like them or didn't use them ), which is to highlight the vid from start to finish (you can check the timestamp to make sure it starts at 00:00 and ends at 1:27 to make sure you didn't accidentally cut anything off ) then I go to Render As and make sure that "render loop region" has a check next to it.

This is the same procedure as spot rendering, just in this case rendering the entire vid. Then that way I can control exactly how much the vid renders, in case it picks up some stray clip down the timeline and is trying to include that.

[FaradayLinus]